Camera Accessory

Metal square hood for Fuji X100 series. It consists of two parts, the hood ring (with O-ring) and the hood body. The O-ring acts as a rotation stopper to allow the hood to be set and attached in a parallel position. .The high-grade finish of the aluminum construction gives the hood a sense of unity with the camera even after installation.

Square Lens Hood with a CapThis is a high-grade square hood that is used by attaching a special aluminum ring (39mm/43mm...

A metal wide angle hood made from a single piece of ground aluminum for 24㎜ wide angle lens. The hood has filter thread on the tip to attach a lens cap etc. The inner matte coating is carefully finished by Japanese craftsmen one by one.

A black metal lens hood made of solid ground aluminum for a standard 50mm lens. The hood has filter thread on the tip to attach a lens cap or filter. The inner matte coating is carefully finished by Japanese craftsmen one by one.

When extended, the angle of view is about 24 degrees, suitable for telephoto lenses of 100mm or more. When folded, the angle of view is about 54 degrees, and it can be used with standard lenses to medium focal length lenses of about 80mm.

Designed to be folded in two steps. This is a rubber hood for wide angle lens system, covering from standard lens to wide angle 28mm lens. When the hood is fully extended, the angle of view is approximately 64 degrees, which can be used with standard lenses and wide-angle 35mm lenses. When folded, the angle of view is approximately 76 degrees, making it suitable for use with a wide-angle 28mm lens.

This rubber lens hood is made by craftsmen who carefully process burrs, etc. that occur during the manufacturing process of rubber hoods one by one. The flexible, rubber, foldable lens hood allows you to keep it attached to your camera at all times. When shooting, the hood can be extended with a single touch. The hood can also be flipped over and stored together with the camera case.