Lens Hood

This is an original aluminum filter ring for the FUJIFILM Xhalf that allows you to attach a 34mm filter to the FUJIFILM Xhalf.

This is an U.N' original 52mm Dome Hood for NIKKOR Z mount lenses which is machined from aluminum.

This is a plastic front cap for the UNX-8133-UNX-8135/UNX-8117/UNX-8118 square hoods. It can also be used with the genuine Leica square hood 12501 (Leica M Super Angulon 21mm f/3.4/Elmarit 28mm f/2.8).

49mm Ring (Female/Female) for FUJI FinePix X100/X100sBy detaching the lens front ring of FUJI FinePix X100/X100s/X100T/X...

Metal square hood for Fuji X100 series. It consists of two parts, the hood ring (with O-ring) and the hood body. The O-ring acts as a rotation stopper to allow the hood to be set and attached in a parallel position. .The high-grade finish of the aluminum construction gives the hood a sense of unity with the camera even after installation.

A metal wide angle hood made from a single piece of ground aluminum for 24㎜ wide angle lens. The hood has filter thread on the tip to attach a lens cap etc. The inner matte coating is carefully finished by Japanese craftsmen one by one.

A black metal lens hood made of solid ground aluminum for a standard 50mm lens. The hood has filter thread on the tip to attach a lens cap or filter. The inner matte coating is carefully finished by Japanese craftsmen one by one.

When extended, the angle of view is about 24 degrees, suitable for telephoto lenses of 100mm or more. When folded, the angle of view is about 54 degrees, and it can be used with standard lenses to medium focal length lenses of about 80mm.

Designed to be folded in two steps. This is a rubber hood for wide angle lens system, covering from standard lens to wide angle 28mm lens. When the hood is fully extended, the angle of view is approximately 64 degrees, which can be used with standard lenses and wide-angle 35mm lenses. When folded, the angle of view is approximately 76 degrees, making it suitable for use with a wide-angle 28mm lens.

This rubber lens hood is made by craftsmen who carefully process burrs, etc. that occur during the manufacturing process of rubber hoods one by one. The flexible, rubber, foldable lens hood allows you to keep it attached to your camera at all times. When shooting, the hood can be extended with a single touch. The hood can also be flipped over and stored together with the camera case.