UW Bracket ＆Grip

This is a set of lanyard plates for attaching a lanyard to the underwater grip. You can attach your favorite lanyard to the grip at your desired length. With the lanyard attached, it is very convenient to carry on land, during entry and exit. Two types of nuts are included, so you can attach the plate to the grip with the base.

U.N short grip stay designed for waterproof compact cameras/compact housings such as the Olympus TG-6 and action cams such as the GoPro.The UNZ-2517U.N Base can be attached on the lanyard plate on the top of the grip using the included long bolt to allow you to attach a U.N clamp or arm to shoot with a small strobe or light.

U.N Grip S Type BThis grip attaches to the U.N. Bracket S Set and U.N. Grip Stay S/M. This grip is installed on the oppo...

This grip attaches to the U.N Bracket S Set or U.N Grip-Stay S/M. The grip is attached on the opposite side of the conventional grip to hold the camera on both sides for a stable and secure shooting experience.

The U.N Grip-Stay S is an underwater bracket with two screws for compactness. A rubber sheet is attached on the stay to improve adhesion to the housing. This helps to prevent scratches on the bottom of the housing as the aluminum bar is not directly attached on the bottom of the housing.

This product is a grip stay only without arm from the U.N Bracket S Set. By attaching on a protector, you can have a better grip and support underwater shooting.

This is a grip stay for ikelite underwater housings. There are no restrictions on the grip stay itself, so you can set the grip on any side you like.

U.N Grip Stay M　A grip stay for underwater housings that is fixed with two camera screws. The grip stay itself is not re...

This bracket S set is smaller and lighter than conventional products due to its lightweight and compact design. The camera screw can be adjusted by 4 mm by adjusting the washer. The bracket is not fixed type to prevent rattle but has 10mm working range to accommodate more protectors. INON type strobe mount.

This bracket S set is smaller and lighter than conventional products due to its lightweight and compact design. The camera screw can be adjusted about 4mm by adjusting the washer. The bracket is not fixed type to prevent rattle but has 10mm working range to accommodate more protectors.